Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Stock 289 decided to install a cam, intake, holley 600, Doug Thorley ceramic coated headers, and electronic ignition. All went well until the comp 270H lost a couple lobes, so I replaced it with a Summit-3601 inexpensive cam. That was fixed then the edelbrock performer intake would not seal, three attempts, so I bought a Summit stage 2 intake and it sealed right up. I also did springs, valve seals, lifters, timing chain, and water pump. That summit stuff seems to be very good quality or I just finally got it right....
 

Attachments

·
Registered
Joined
·
134 Posts
Perhaps a bit of both! I actually like the Summit branded stuff and the prices are hard to beat!
 
1 - 2 of 2 Posts
Top