Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a 67 mustang convertible 6 cyll stick that i want to put a 289 auto into.
does anybody have enough experience with this to provide a detailed list of parts needed to do the swap. Also whear i might best go for parts and or assemblys. or possibly even a publication with related info.
i do already have the 289 and auto trans. however the trans is most likely set up as a colum shift.
so far it the best recourse i have come up with for parts is "mustangs unlimited."
 

·
Registered
Joined
·
682 Posts
You'll need a V8 rear, either a stock 8" or, if your running a lot of power, a 9". You'll need a V8 radiator, engine bay wiring, and front brakes. I'm not as farmiliar with doing this on a 67-68 as I once was, so that might not be a complete list. Rest assured that you have a lot less to change than on a 65-66.

USUALLY collum shift trannys just need the main linkage stub flipped the other way for floor shift, but I can't desciribe this very well.

Stay away from MU. For that matter, stay away from Mustangs Plus (**** are they ever expensive!) Try NPD, K.A.R, or Ponderosa Mustang.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top