Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,275 Posts
Discussion Starter #1
Does anyone know if Ford used standardized ignition tumblers and door locks across the board in 1969? I need a matching set for 69 F-100 and the truck websites want $69 while the Mustang sites only want half that. They look the same to me, but then I'm only looking at pictures on a webpage, not actually holding them in my hand side by side.
 

·
Registered
Joined
·
121 Posts
They are very likley the same
May be only differance will be lift up or push down on shaft
This will be resolved by changing out the arm on the back
If you have a pick and pull junk yard around I would go there and locate something that matches.
Remember most lock shops can rekey any locks you find to all match
Mike
 

·
Registered
Joined
·
5,978 Posts
Look up the sites return policy if there is no restocking fee just buy it and send it back if it don't work.Also call a local locksmith some are cheaper then i could buy stuff for online.
 
1 - 3 of 3 Posts
Top