Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
Hi,
After jacking up my car to replace the tie rods, I noticed the harness that connects the o2 sensors to the harness had been dangling and the connector on the harness side had been damaged beyond repair. I went to the Junkyard and pulled the connector from the only 5.0 mustang they had. Apparently it had heated sensors and the connector has one extra pin, so it wont work.

Is it possible to hard wire it? and what other vehicles could i pull the connector off of if not?
Please help, this is my DD and I dont like driving withouth those sensors :confused:
 
1 - 2 of 2 Posts
Top