Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
I recently bought some GT40P heads without pushrods off Ebay and I bought new hardened pushrods for them also. How do I install them? If I understand it right, I need to check piston to valve clearance. Do I need to crank it over until each piston raises and tighten down individually? If so, what is the order for the pistons?

I am still new to all this and soaking up all I can. :worship Any info or articles would be very helpful!
 

·
Registered
Joined
·
2,306 Posts
1 - 3 of 3 Posts
Status
Not open for further replies.
Top