Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
looking over my wires today and noticed a mouse chewed the insulation off one injector wire. small spot about half inch long, looks like it could be fixed and wire only had a couple strands broke. would these strands be enough to effect the voltage of the injector? also i cant find this harness new so guessing i would need one off another car is this right. thanks in advance for any help mike.
 

·
Registered
Joined
·
1,072 Posts
Repair

Is there room between the connector and the break to splice in a repair? If so, cut and strip both sides of the wire. Slide 2 pieces of shrink tubing over the wire and leave them. Use a small jumper wire of the same gauge and solder it in on both sides. Slide the shrink tubing over each joint and heat until shrunk. If the knick isn't that bad and you're experiencing no issues I might just put electrical tape over it, though. All depends on what you want, boss.
 
1 - 2 of 2 Posts
Top