Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello Everyone:

I am Willie from California. I am trying to replace the fuel sending unit on a ford mustang (68).
My question is regarding the O-ring. It seems like it is either too small or too big. Where does the O-ring actually go on the gas tank in the grooves? On top of the sending unit.....It seems too small to stretch to the edges when I do this?

The diameter of the o-ring I was sent is 2 and 1/2 inches.

Thanks.

Willie
Monterey, California
 

·
Registered
Joined
·
41,825 Posts
Hey Willie lets see if we can get a an answer in this section. Welcome to the site.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top