Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,757 Posts
you shouldnt need any sealant. The adapters have rubbers already in and around them. Id first suggest being very very carefull with this. especially with sparks and everything. make sure nothing falls in anywhere around the coils.. Make sure your running 42ish fuel psi.. might have a faulty regulator or have it turned up or somthing telling it to give you insane fuel pressure. totally stupid comment. but it could happen
 

·
Registered
Joined
·
1,757 Posts
still. be very carefull with fire prevention. yours dont have the rubbers? do they fit snug? if they do any they still leak. use some of that gasket sealer. not the tape. the one you squeeze on outa the tube. just some around the threads. then tighten down to specs. then turn the car to ACC about 3 times to build pressure. and if theres no leaks. make sure your running about 42psi...
any fuel system builds i suggest aeroquip fuel plumbing supplies.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top