Ford Mustang Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
214 Posts
Discussion Starter #1
So I disconnected my EGR due to clearance when I installed the fuel pressure gauge. The connector from the main harness will not plug into the connector on the EGR sensor, as the FP gauge takes the space where this connector exists.
Is there any way to make up this connection if I want to put back my EGR system ? any extension in the market??
 

·
Registered
Joined
·
912 Posts
i would put your gauge somewhere else, like a pod on the cowl or mount it to the inside of the firewall if you want to see it from the bay, and run a braided line to it, so its not blocking anything
 

·
Registered
Joined
·
912 Posts
Most would install the gauge off the schrader valve.
thats what i was thinking, run a line from the valve to a gauge put where you want it to be.
 

·
Registered
Joined
·
214 Posts
Discussion Starter #5
That sounds like a good idea guys.. thanks..
I was just thinking if there is any smaller plug(s) with extension used for this reason... Of course the other option i have is to block off the EGR and put an EGR simulator, I am just not sure if that will cause any problems later or not. I dont have an air pump and no CATs.
 
1 - 5 of 5 Posts
Top