Ford Mustang Forum banner

Anybody with Ford Racing Headers?

908 Views 2 Replies 3 Participants Last post by  05GTSILVER
How hard were they to install? How do you like them?

Tim
1 - 3 of 3 Posts
Got a set of SVT Shorties on mine. Not too bad of install. Need to remove steering column shaft to make left side an easier fit. Also should retorque after about 2K miles. Got about 10K miles on these. They are not as "Stainless" as they should be. Also, had to cut factory H-Pipe to get it to fit the "Bolt on" headers. Overall, not bad, but they could use a bit of improvement. Performance is good though.
918chef said:
How hard were they to install? How do you like them?

Tim
i got them, they look pretty and keep the engine bay a bit cooler, bc mine are ceramic coated. but for power, get some kooks long tubes.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top