auto transmission swap 89 to 93

1189 Views 5 Replies 5 Participants Last post by mg man 75, Mar 10, 2015

fireman348

Discussion Starter · Mar 9, 2015 (Edited)

i swapped a transmission from a 89 into a 93. The electrical connector from the engine to the transmission on the 89 car is a 2 pin, on the 93 it is a 3 pin. is there an easy fix for this or will the trans out of the 89 not work in the 93. Both 2.3l cars.
any help would be good.

Save

1 - 2 of 6 Posts

fireman348

Discussion Starter · #3 · Mar 9, 2015

trans swap

I found the problem. the trans out of the 89 will not work. the 2 pin is for the torque convertor. on the 93 the 3 pin controls the torque convertor and the solenoid pac. so the TCM and the PCM won't work together.
thanks for letting me post hopefully it helps others.

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Model Specific Forums
2.3L and SVO Mustang Forums
2.3L Tech
auto transmission swap 89 to 93

Top Contributors this Month