[tucsondivots]

Brushed Aluminum Fuel Door

I just purchased a brushed aluminum fuel door from the guy in Canada. Should arrive next week. IMHO it does not look tacky.

This is a url for the one I bought with the embossed Pony.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=7993272989&sspagename=STRK%3AMEWN%3AIT

Tucsondivots
2005 Windveil Blue, V6, Leather, Shaker 500, Automatic
:worship

 

[tucsondivots]

The guy in Canada is: [email protected]

I will post pictures later this week when it arrives and I install it.

tucsondivots
2005, V6, Auto, Leather, Shaker 500, Bob While Decals

 

[tucsondivots]

Got the Brushed Aluminum Fuel Door today and will install tomorrow.

Looks very well made and fit seems perfect. It has an embossed pony in the middle.

I will post pictures by the week-end.

tucsondivots
2005, V6, Windveil Blue, Auto, Leather, Shaker 500, Bob White Decals, Spoiler:drool:

 

[tucsondivots]

Billet Fuel Door (Photos)

I installed the brushed aluminum fuel door and am attaching some photos.

Was an easy install. I am pleased with how it looks.

tucsondivots
2005, V6, Windveil Blue, Leather, Spoiler, Shaker 500:worship

 

[tucsondivots]

Rickman,
Great looking ride!

Tucsondivots:drool:

 

[tucsondivots]

Billet Fuel Door (install answer)

It has 3 bolts. Here is the quick install info:
--Remove the two bolts holding in the current fuel door (on the left) and remove the fuel door
--Remove gas cap wire and cap from removed fuel door
--Take gas cap wire and cap out of current fuel door
--Take out both grommets on right side (where door hits when it closes)
--Install gas cap wire into top hole where grommet was removed.
--Fuel door has three bolts, two where the original bolts were and one that goes through the bottom grommet that was removed --Door fits snug (perfectly) onto those three bolts. Nuts, washers, lockwashers go on and you're done.
Note: The only challenges were getting the gas cap wire through the top grommet hole and getting the nuts tightened on the three bolts. You need a very short (ingnition type) 3/8" wrench to get in the small space to tighten nuts, washers and lockwashers.

tucsondivots:winks