Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
I have a 98 stang and I just purchased a set of rotors and brake pads for the rear. I am simply asking if it takes a lot of work to do this myself??? I dont really want to take it to the ford dealer if I can do this myself. Does anyone have any step by step procedures for changing these out myself? Thank you in advance...:wavey
 

·
Registered
Joined
·
72 Posts
Breaks

It's not a bad job if you have all the tools. a set of general hand tools and one special tool for turning in the piston on the rear caliper. that can be bought at any good auto store. it just hooks into the piston and allows you to turn it clockwise until its in. also use break lub on the contact points, ( not the pad to the rotor ). good luck
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top