Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
367 Posts
Discussion Starter · #1 ·
I pulled on my dipstick tube too hard while checking the oil. I can get it back in, but it is loose. Does anyone know if I am supposed to put sillicone, or epoxy to hold it in? I can tighten the mount for the tube, but what about the connection of the tube and the block? surely there is a seal or hi-temp sillicone that creates a seal. Please help.....the people at AutoZone have a combined IQ of 62!!
 

·
Registered
Joined
·
367 Posts
Discussion Starter · #6 ·
Thanks for the info. I think I'll use high temp sillicone and try to secure the tube to a different location. Just wanted to make sure it wouldn't start spewing oil, cuz I haven't run it since the tube came out.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top