Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
206 Posts
Discussion Starter #1 (Edited)
I have a 1971 Mustang with a 2v 351C and a C4 A/T equipped with a ratcheting ( i think) B&M shifter. So here's the deal....whoever owned it before me installed the previously mentioned shifter about 3 inches behind, what i think is, the stock shifter hole. so, my question is, should i just seal the hole with some metal or get a new shifter? also i would prefer one that would hook up through the stock shifter hole. Any recommendations? Thanks
 

·
Registered
Joined
·
517 Posts
I would make sure that all he installed was a shifter... If he did i dont know why it would be in a different spot but I would get it back to the factory location if you can and if not fill the whole not permanently just incase you change it in the future
 

·
Registered
Joined
·
206 Posts
Discussion Starter #3
I plan on changing it. i just don't know what shifter i should get...i was kind of thinking along the lines of hurst.. but i don't know.
 
1 - 3 of 3 Posts
Top