Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
What should my next mod be on my 97 cobra? Im looking at a JLT cold air induction or a accufab throttle body. And to put in the intake do i have to remove my stabalizer bar or will it fit underneath?
 

·
Registered
Joined
·
70 Posts
CIA...The stock TB flows more than enough for most N/A applications. My BBK CIA fits under my KBrown strut brace, like a glove, yea it's tight. I did have to unbolt the passenger side of the brace to lift it just enough for install.
 

·
Registered
Joined
·
88 Posts
I don't have a mod cobra but I think as a rule of thumb an intake always comes before a throttle body, or better yet at the same time!
 

·
Registered
Joined
·
1,707 Posts
as gr40 said, our tb's flow more than enough. a larger tb is not needed until forced induction.

as far as JLT fitting under the strut tower brace.....nope

i have a densecharger but mine wont fit under a stb either.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top