Ford Mustang Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
I am sure it can be done, obviously since the engine is coming out of a 96 T-Bird I totaled back in November; it would get re built. I have seen a couple of modular foxes, always 4 valves though. I take it you would need the wiring harness's and ECU from the T-Bird for it to work right? If anyone knows anything about doing a swap like this that would be great.

I have to get all new wiring for the car anyway, the car started life as a 2.3. Then the former owner butcherd most of the wiring and dropped a carbed 302 in it.
 

·
Registered
Joined
·
7,401 Posts
You would also need the conversion motor mounts or K Member
 

·
Registered
Joined
·
5,089 Posts
+1 and it's been done. I've see fox bodys with the Terminator set up.
 

·
Registered
Joined
·
5,329 Posts
You'd need the k-member for a mustang, exhaust, cooling system, intake system, wiring, ecu, transmission, and a bunch of nbs parts, but it can be done. Honestly, there is really nothing that can't be done, but it will be a lot of work to do it right.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top