Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
315 Posts
Discussion Starter #1
Alright well my car would run bad and die at stops. So i replaced the distributor and tfi module thinking it was that. It ran better but still died when stopped or slowed down to turn, etc. I parked it at home and ran the scanner and got the engine codes. I disconnected the battery to reset the codes. I went to start it again and it just cranked. It has fuel at the schrader valve. I replaced the starter solenoid and battery cables. For some reason my alarm works now, because it didn't before. Now it just cranks and when i let the key go back into the ignition position the engine kinda knocks or shakes like it still wants to turn over. Any ideas? I can run any codes because i cant warm the engine up. Im wondering if the thing that would cause it to die at stops before is whats causing it to not start now??
 

·
Registered
Joined
·
348 Posts
did you try replacing the starter its self?
 

·
Registered
Joined
·
315 Posts
Discussion Starter #3
No i was gunna do that next or atleast get it tested. Cant seem to find it though:headscratch:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top