Ford Mustang Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
897 Posts
Discussion Starter · #1 ·
My '86 has a strut brace that end up in plates that are bolted to the original camber adjustment bracket on top of the strut, no drilling was required. Have tried to figure out which brand it is but no label or marks anywhere. This brace was installed back in 1993 by the previous owner of the car and, has hold the front chassis very well, would like to keep it.

Now, which caster/camber plates could be used with a strut brace of this type ? I ask, because the offerings I see could create a clearance problem with the hood. Doesn't matter the brand I just need to be able to adjust the caster angle on the right side and keep the strut brace, it's a little off spec and that front tire is always the first one to go.

Any information is appreciated...Thanks.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top