Ford Mustang Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
316 Posts
Discussion Starter #1
Hello Everyone,

I was hoping that somebody on this site would know the solution to this dilemma. I will be converting to a dual exhaust system next summer. Currently, I have a single Flomaster AT fitted on my car. I have noticed that most every dual conversion kit I find requires the catback diameter of the GT (3.5"?) to fit on these kits. My Flomaster is practically brand new only a few thousand or less miles on it. It would be a shame to have to buy two brand new catbacks, instead of just one. Does anybody know of a way around this, or a kit that is compatible with V6 catbacks?

Thanks.
 

·
Registered
Joined
·
316 Posts
Discussion Starter #3
you are correct, that is why I had a question mark after "3.5"." But I do know that the V6 diameter would then be 0.50" smaller. Do you know any way around this, or do I have to buy two GT CB's?
 

·
Premium Member
Joined
·
72,882 Posts
You should be able to have an exhaust shop just put it on a pipe expander if you need to.
 

·
Registered
Joined
·
316 Posts
Discussion Starter #5
good idea. I will ask my shop about this. Thanks.
 

·
Registered
Joined
·
316 Posts
Discussion Starter #7
I'd say so. It'd save about $250.00. Thanks, again. I wasn't sure if this was possible.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top