I'm soooooo close to pulling the trigger on these.... Looking forward to see your pics!!! HURRY UP!!! LOL!
CDC Rear window louver delivered
Just got the CDC Rear window louver today... anyone else got one of these? Any problems installing it? I'm going to install it and post some pics.
- Status
- Not open for further replies.
1 - 11 of 11 Posts
Sure thing. The installation looks pretty straight forward... it comes in two large pieces and some hardware. The pieces bolt together and have hinges on one side and latches on the other. The instructions do say it must be around 70 degrees which sucks, I haven't seen a 70 degree day around here in months.
Your welcome to pay a visit to my heated garage.:winksjim83181 said:Sure thing. The installation looks pretty straight forward... it comes in two large pieces and some hardware. The pieces bolt together and have hinges on one side and latches on the other. The instructions do say it must be around 70 degrees which sucks, I haven't seen a 70 degree day around here in months.
(It's a clean burning kerosene heater, but hey it works!)
I would but I have it garaged (not heated) right now. and its under storage insurance. Maybe I'll get a small heater myself.
Installed the CDC rear window louver in November. Posted the trials and tribulations that went along with the install. Not too bad - just read the instructions carefully and find the true center of the top of with rear window. The template is right on the money. The clips on the edges (one each side) can be a bit testy but went on with a few easy taps from a rubber mallet. Believe another mustanger used a grinder to take a bit off the top window edge clips to ease installation; when you look at the clips and try a test fit you will know what I am talking about. Believe he also used some flat black paint on the nuts/bolts that hold the upper and lower louver sections together. The louvers really cool off the back seat area and rear visability is unaffected. I always imagine it flying off as I go down the road but the 3M adhesive really sticks. Good luck and enjoy!
I just posted to a similar message on the lounge board.
http://www.allfordmustangs.com/forums/showthread.php?t=52883
http://www.allfordmustangs.com/forums/showthread.php?t=52883
Thanks for the tips Ash, I am really looking forward to putting it on.Ash GT said:Installed the CDC rear window louver in November. Posted the trials and tribulations that went along with the install. Not too bad - just read the instructions carefully and find the true center of the top of with rear window. The template is right on the money. The clips on the edges (one each side) can be a bit testy but went on with a few easy taps from a rubber mallet. Believe another mustanger used a grinder to take a bit off the top window edge clips to ease installation; when you look at the clips and try a test fit you will know what I am talking about. Believe he also used some flat black paint on the nuts/bolts that hold the upper and lower louver sections together. The louvers really cool off the back seat area and rear visability is unaffected. I always imagine it flying off as I go down the road but the 3M adhesive really sticks. Good luck and enjoy!
Thanks myltlpny, Great shots!myltlpny said:I just posted to a similar message on the lounge board.
http://www.allfordmustangs.com/forums/showthread.php?t=52883
1 - 11 of 11 Posts
- Status
- Not open for further replies.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
