Ford Mustang Forum banner

cleveland machine work?

509 Views 1 Reply 2 Participants Last post by  PaulS
i was just wondering what machine work runs money wise, im building a 351c and i found a good block that needs to be gone through, balanced and blueprinted, bore .30 over, turn the crank, recondition the heads with hardened seats. what would something like that cost. im planning on 350-400 hp, thanks
1 - 2 of 2 Posts
Machine work prices vary from one local to another. What would be considered cheap in my area might be more expensive than any place in your area.
Parts can be had from the net that are less expensive than most shops charge but they may not wish to use parts that you buy - or they may charge more if you supply the parts.
See less See more
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.