Ford Mustang Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter #1
Any recommendations on which brands to get for these parts?
 

·
Premium Member
Joined
·
72,878 Posts
I'd recommend a SPEC clutch and flywheel but I'd go with steel. I have an aluminum f/w and don't really care much for it.
 

·
Registered
Joined
·
197 Posts
Discussion Starter #3
I'd recommend a SPEC clutch and flywheel but I'd go with steel. I have an aluminum f/w and don't really care much for it.
Why? I am looking to reduce mass.
 

·
Banned
Joined
·
9,214 Posts
i went spec stage 2


stock steel clutch


motive 373s
 

·
Registered
Joined
·
9,239 Posts
I have an aluminum f/w and don't really care much for it.
Why, what does it do that you don’t like? Aside from mine being an on/off switch it works fine.
 

·
Registered
Joined
·
249 Posts
Any recommendations on which brands to get for these parts?

My opinion a spec 2+ with steel instead of aluminum, FRP 3.73's and a shaftmaster drive shaft. plus replace the hydraulic slave when you do the clutch.

If FI is in your future I would go to a spec 3+.

Why steel? I preferred the driveability of the steel fly wheel over the aluminum I had. Went back to steel when the opportunity came.
 

·
Premium Member
Joined
·
72,878 Posts
I don't like the aluminum because it takes too long to spin down. Plus they have a tendency to crack.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top