Status
Not open for further replies.
Joined Oct 8, 2005
·
64,487 Posts
Pic is a little blurry Pete. Let me look and see what I can find.
Joined Oct 8, 2005
·
64,487 Posts
I'm not sure if this will help or not, but it's worth a shot.
I looked at that one too David. I'm going to check Alldata.
Joined Oct 8, 2005
·
64,487 Posts
Pete, why do the A/C controls need to be disconnected?
Joined Oct 8, 2005
·
64,487 Posts
This is all I can find on Alldata. Doesn't talk about how to remove the connector.
Joined Oct 8, 2005
·
64,487 Posts
The panel that has the climate controls on it is in front of the radio, there is not enough slack to move it out of the way so I can pull the radio out.
Can't you just disconnect the A/C controls from the center panel?
Joined Oct 8, 2005
·
64,487 Posts
I can pull the panel out about an inch, I think I can get at those 4 mounting screws in your diagram out with a small hex wrench.
Didn't realize that you didn't have any room to maneuver. There's probably a special Ford tool :so
Joined Oct 8, 2005
·
64,487 Posts
Got it! with the help of your climate control diagram, I managed to get the screws out, not bad, they are pretty short.
Good deal... What stereo are you putting in?
Joined Oct 8, 2005
·
64,487 Posts
My gawd you have to be a contortionist to get the connectors off that radio.
I am putting in a Alpine CDA-9885. For $207.00, I couldn't pass it up.
What did you have in there before?
Joined Oct 8, 2005
·
64,487 Posts
Gotcha... Thought you had a Shaker 500.
Status
Not open for further replies.
You have insufficient privileges to reply here.