Ford Mustang Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I switched my 1990 stang to a carburetor. I would like to keep my factory oil pressure and temp. gauges without all the extra wiring. Does anyone make a harness that will plug into the main harness? I would appreciate any info or pictures on how to do this if it can be done.
 

·
Registered
Joined
·
46,010 Posts
You could check out Painless Wiring to see if they have that harness you need.
 

·
Registered
Joined
·
38 Posts
you could do what a friend and i did when we did the conversion...we took the factory harness and traced the wiring for just the temp sensor and oil pressure sensor then cut out all the other wiring that was not used.
 

·
Registered
Joined
·
504 Posts
I bought a trailer wiring harness and spliced that in there when I replace some plugs. Those have 4 wires, but you can just use what you need.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top