Ford Mustang Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
154 Posts
Discussion Starter · #1 ·
Last night is the first time that I have really driven my car since I bought it and I have a few questions.

First, my stock oil pressure gauge stuck on the L and right below it pretty much the whole time I drove it. I also kept hearing chatter from my engine when I would accelerate. I know that I am not low on oil, so would that mean my oil pump is weak?

Second, what is normal operating temperature? My car would fluctuate between top of the R to middle of the N. Seems too high to me. Also, would turning on your headlights make your car hotter? I really don't think so but everytime I turned them on it would jump probably 10 degrees.??

Lastly, I just replaced my starter and noticed that my flywheel dust shim is garbage. It looks like whoever did the tranny swap in my car cut the circle out for my starter, broke the bottom 1/4 of the whole shim and now the two pieces overlap. I had to bend both parts out in order for them to stay off of the flywheel. I am looking for a new shim and I have seen two different ones on ebay, a one piece and a two piece. Any ideas to which one I need. Also another question about this, before I replaced my starter, my clutch did not make any noise. Now when I push in my clutch I hear kind of like a ticking sound. When you push in your clutch, does it push your flywheel out some? I am wondering if it is my flywheel hitting the shim is what is making the ticking noise.

Thanks for reading
 

·
Registered
Joined
·
154 Posts
Discussion Starter · #5 ·
Any idea's why turning on my headlights would make my water temperature go up?
 

·
Registered
Joined
·
154 Posts
Discussion Starter · #8 ·
So for my oil gauge issue, I bought another oil pressure gauge and hooked it up. When I first turned the vehicle on at idle it was sitting right below 50 psi. After a while of it warming up it was right above 25psi. It still wasn't at the driving temperature when it is at its lowest. Does this mean it is definately my oil pump? One of the guys at the shop said to check cylinder compression. How would this affect my oil pressure?
 

·
Registered
Joined
·
154 Posts
Discussion Starter · #10 ·
Also, does your oil pressure sending unit affect the pressure or is it just a sensor?
 

·
Registered
Joined
·
154 Posts
Discussion Starter · #12 ·
What type of gauge did you buy? Mechanical or electrical?

Mechanical doesnt have a sending unit sensor.
I bought a mechanical but I was wondering if the stock sending unit corrects the pressure or is it just a sensor?
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top