Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Recently Got A 93 Cobra Whith A Crane Interceptor I Installed,i Dont Have The Passcode And Can't Get It Out From The Monitoring Screen To Adjust It, It Just Keeps Asking For The Passcode To Log In,is There A Way To Reset It :?: Thnks For The Help....
 

·
Registered
Joined
·
579 Posts
I guess you have tried the default code 1234. I have tried to reset the units for people in the past and even removed the eeprom chip and cleared the chip and the code still was saved. I am not sure what memory register because I tried for someone and the way he got his unlocked was to try every combination but he figured out the code after only a week. The Interceptor I, I am sure using the same passcode system as the Interceptor II and since nobody supports our units and the passcode system is different than the new PMS so no help on that front.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #3 ·
I'VE TRIED 1234 AND 0000 (THIS IS THE BYPASS FOR INTERCEPTOR I) AND NOTHING JUST GOES BACK TO MONITORING SCREEN AND ANITHING YOU TRY TO DO,ASKS YOU FOR THE PASSCODE :sosad:
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top