Crankshaft relearn procedure with procal?

7689 Views 7 Replies 3 Participants Last post by 5LITER_MUENSTER, Oct 9, 2012

5LITER_MUENSTER

Discussion Starter · Oct 8, 2012

Is there a certain way I have to do this? I blipped(tapped) the throttle to 3k rpm as instructed but the CEL is not turning off. Could my TPMS light prevent this? If not, what is the proper procedure to do this correctly?

Thanks in advance.

Sent from my HTCEVOV4G using Tapatalk 2

Save

1 - 8 of 8 Posts

5LHO

· #2 · Oct 8, 2012

rev it higher....

Save

Black Dragon

· #3 · Oct 8, 2012

keep revving it a little higher each time until it goes off. I've had to go as high as 6k on some cars...

Save

5LITER_MUENSTER

Discussion Starter · #4 · Oct 8, 2012

So just keep tapping the throttle pass 3k rpm and do I wait until the rpm come back down to normal idle to tap the throttle again?

Thanks guys.

Sent from my iPad 3 using Tapatalk HD

See less See more

Save

Black Dragon

· #5 · Oct 8, 2012

Yes, one blip at a time...

Save

5LITER_MUENSTER

Discussion Starter · #6 · Oct 8, 2012

How many times do you have to tap the throttle usually?

Sent from my iPad 3 using Tapatalk HD

Save

Black Dragon

· #7 · Oct 9, 2012

I've had to go 7-8 taps on some

Save

5LITER_MUENSTER

Discussion Starter · #8 · Oct 9, 2012

Got it! 4k rpm and it went right off. Only took 2 blips. Procal said 3k so I was literally sitting in my driveway just blipping away to 3k lol. Thanks bro.:thumbup:

Sent from my HTCEVOV4G using Tapatalk 2

Save

1 - 8 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month