Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello,
While replacing the pinion seal on my 99 Cobra, I noticed a gap between the washer and the rubber bumper on the bolt that holds the diff on. I tried to tighten the bolt to eleminate the gap and got the bolt as tight as I could get it without breaking the bolt. With 66,000 miles on the car is it possible that these are worn out and has anyone else had this problem?


Thanks,
Chris
 

·
Registered
Joined
·
48 Posts
IRS bushings - gaps - etc

Do you mean the two bushings stack-ups on the front of the diff carrier next to the pinion? If they look suspect then this would be a great chance to replace them with urethane ones that will take some of the slop out of your IRS. There is more info in a post I left in a thread below, including links to a few manufacturers. I did mine at like 12000 km (Canadian car) so I don't know how well they age. Good luck. Jim.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top