Ford Mustang Forum banner

Drive Shaft on a '65 Fastback

1059 Views 3 Replies 3 Participants Last post by  MustangKid'65
Hey guys! We were getting ready to start dropping the engine in and were looking at all the related parts when we noticed our drive shaft had a bend in it. So we looked around and found a '68 drive shaft which we were told could be interchangeable. However, the base of the shaft is different, and the diameter in general is larger than the 65. It is the same length though. So I guess the basic question is, can I replace the '65 drive shaft with the '68? Thanks!
1 - 2 of 4 Posts
Thanks to both of you! I'll be sure to let you know how it all works out! Thanks again!
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.