[mattsadagursky]

http://pysales.com/inst/SFM68-69-bumper-cutout02.pdf

I found this Pypes bumper cutout template I just had a few questions about it.
Is this for the 2006 V6 4.0L S197?
This is for the driver side cutout to support the 2nd muffler correct?
What are some good tools to use when doing this? I am extremely amateur with this so I'm looking for the easiest thing that is going to look the best.

 

[Brianwu]

I'm pretty sure that's the right template. The sfm68 is their dual exhaust model for 05-09 v6s. I would suggest a dremel or similar rotary tool if you have one. If not, probably a brand new sharp knife considering the valence is plastic. Just take your time. Cut out a big chunk that doesn't go too close to the outline, then slowly shape it. Patience is key because you don't want to cut off more than necessary!


Sent from AutoGuide.com Free App

 

[mattsadagursky]

I'm pretty sure that's the right template. The sfm68 is their dual exhaust model for 05-09 v6s. I would suggest a dremel or similar rotary tool if you have one. If not, probably a brand new sharp knife considering the valence is plastic. Just take your time. Cut out a big chunk that doesn't go too close to the outline, then slowly shape it. Patience is key because you don't want to cut off more than necessary!


Sent from AutoGuide.com Free App

That sucks. I wanted to get dual conversion and Borla S Type. Do you know where I can find a template like that for the driver side?