Ford Mustang Forum banner

Dynoed my '66 Mustang! (Video)

1475 Views 15 Replies 4 Participants Last post by  happystang
I've been meaning to do this for so long, the curiosity was killing me.

Specs are as follows:

1995 302 V8
1987 T-5 manual transmission
Edelbrock Performer RPM intake
Holley 600 Vac secondaries
Hedman Headers middys
24inch cherry bomb glasspacks
MSD ignition

Stock rear end, 2.79 gear ratio.

It's pretty stock, I tore it apart replaced all gaskets and cleaned up the carbon build up on the cylinder heads. Motor has maybe 84xxx on it.

A/F read out showed it was running way lean and I still have room for more advance on the timing. Dyno guy said go up at least three jet sizes :kooky:

Now, what everyone wants to hear!

It put down 240 horsepower and 290 ft/lbs of torque at the wheel.

I'm very happy with this number considering my estimate was 200 tops considering they only made 215 new.

1966 Mustang 302 Dyno! - YouTube
See less See more
1 - 1 of 16 Posts
What RPM's do you need to run at to get the Dyno results?
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.