Ford Mustang Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
477 Posts
Discussion Starter #1
i recently ordered a new EGR valve for my 91 GT 5.0 and I ended up overtightening one of the bolts that secures the sensor to the EGR, leaving me with only 2 bolts, instead of 3. Is that ok? also, the EGR valve i ordered from 50 resto came with two seals...one i know is for the sensor, but where does the other one go? any help, thnx!
 

·
Registered
Joined
·
39 Posts
I did that to my egr valve , all I did was apply vacuum to the port to make sure it still holds the valve open, mine did but for good measure I added a bead of rtv silicone just in case.
 

·
Registered
Joined
·
477 Posts
Discussion Starter #3
I did that to my egr valve , all I did was apply vacuum to the port to make sure it still holds the valve open, mine did but for good measure I added a bead of rtv silicone just in case.
can u explain how you applied vacuum to which port, and how? and you put the silicone on the broken off stud? how bout that rubber seal?
 
1 - 5 of 5 Posts
Top