Ford Mustang Forum banner

EGR Valve Question

744 views 4 replies 2 participants last post by  fredfifty 
#1 ·
i recently ordered a new EGR valve for my 91 GT 5.0 and I ended up overtightening one of the bolts that secures the sensor to the EGR, leaving me with only 2 bolts, instead of 3. Is that ok? also, the EGR valve i ordered from 50 resto came with two seals...one i know is for the sensor, but where does the other one go? any help, thnx!
 
#3 ·
can u explain how you applied vacuum to which port, and how? and you put the silicone on the broken off stud? how bout that rubber seal?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top