Ford Mustang Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I just recently installed the eibach drag launch springs in the rear of my 1993 mustang coupe. Now the car sits uneven. I dont know if its supposed to be like that or if the springs are turned the wrong way. Im not sure what to do?
 

·
Registered
Joined
·
326 Posts
what do you mean by uneven? do you mean front is lower than the back? or do u mean all of them are different hights? if the front is lower than the back, thats how some/most springs are made to be. the rear end doesn't drop as much as the front. hope this helps

-Joe
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
The back passenger side is higher then the back driver side. I havent put the front springs in yet. The car was a 4 banger befor so I know nothing is bent. Ive been told befor something about the pigtails of the springs are supposed to be faced a certain way.?
 

·
Registered
Joined
·
46,020 Posts
So what was it?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #8
I have the pig tails of the springs facing the drivers side. It looks good in the garage, and i put a level on the back of car and it says its straight. But ill see what happens after i drive it.
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top