Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter #1
Any one know the best way to connect a three prong elecronic turn signal flasher into the two prong 68 wireing connectors?
I have just changed the three bulb sequential tail/ turn signal set up to an LED system. Besides the cool factor, the increased brightness of the LED's over the 1157 bulbs is a great safety bonus and the lower current draw puts less of a load on the 37 year old wireing.
I want to go to an electronic flasher to fine tune the flash rate and the only ones I could source are three pronged.




http://img.photobucket.com/albums/v213/kechke/ledtaillights011.jpg

http://img.photobucket.com/albums/v213/kechke/ledtaillights026.jpg

http://img.photobucket.com/albums/v213/kechke/ledtaillights025.jpg http://img.photobucket.com/albums/v213/kechke/ledtaillights007.jpg
 

·
Registered
Joined
·
3,104 Posts
Go to a truck stop with supplies for semis. The 2 prong electronic flasher is a very common item as most International big trucks used them for many years. :smoke:
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top