Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
105 Posts
Discussion Starter · #1 ·
I have a 68 mustang with a 289. it was previously a 200 ci inline 6 cylinder with a c4 transmission. when i put in the new engine and t-5 transmission it wont line up with the shifter hole, but i expected that. the entire engine wont sit straight. new frame brackets, transmission mount, (not crossmember), and motor mounts. confused. thank you
 

·
Registered
Joined
·
62 Posts
motor mounts

Your problem might lie within your motor mounts. My car had been converted from an inline-6 to a 302. When we installed my new motor and new motor mounts, it wouldnt fit. We ended up using the old mounts, that had been modified (holes were drilled in different places) It fit perfectly. just a suggestion!
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top