Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
Got a pair of flow tech headers for x-mas, and the porting is oval, where as the factory heads have a square porting. The suface seems like it will still seal with a pair of copper gaskets....any help? Did i get a wrong part?-i havent seen a porting type selection in any other catologs.
 

·
Registered
Joined
·
471 Posts
Make sure you use the oval gaskets supplied with the headers. I tried using square gaskets with those headers and she leaked like you wouldn't believe. When I swapped in the ovals, I made sure to trim them so that gasket material ended uop at the edgeds of the port, while still being oval shaped. it worked out great.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top