Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
Hi guys i have a 1992 5.0 engine with a carburator and i have a f303 cam i would like to install in it, my engine has stock e7 heads of course. Can i get any suggestions on what modificacions if any i would have to do in order to install this 512 lift cam in this engine? thanks for you input, Big Rich;
 

·
Registered
Joined
·
46,020 Posts
It's a simple remove and replace procedure to get it in there. You just need to swap the springs to match the cam.
 

·
Registered
Joined
·
42 Posts
Discussion Starter #3
do you know which springs i should get for this swap? can i use the same stock pushrods? and will the cam flow fine with the stock heads? thank so much for your input, Big Rich;
 
R

·
Guest
Joined
·
0 Posts
do you know which springs i should get for this swap? can i use the same stock pushrods? and will the cam flow fine with the stock heads? thank so much for your input, Big Rich;
you will get no real benefit out of that cam with stock heads.....
 

·
Registered
Joined
·
42 Posts
Discussion Starter #5
will i lose horsepower? or will it have the same horsepower and just sound nice? what you think? i am not looking for a racecar at moment just a nice beat to my dailydriver, what is your opinion?
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top