Ford Mustang Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter #1
A couple of days ago my Front O2 sensor on the drivers side went bad. I don't usualy work on my car, but by looking at the new O2 sensor I got from AM it looks to be fairly easy since its plug and play and I honestly don't want to waste money on an install because Iam a student. I lifted up the car today and chickend out because Iam afraid of the car dropping on me and crushing my body. I bought Jack stands but I do not know where to mount them and while looking under the car I only saw the sensors connected to my midpipe. I know this makes me sound like a newbie but I want to know the exact steps I should take so I don't kill my self, but most importantly I do not want to cause any damage to my car.
 

·
Registered
Joined
·
1,651 Posts

Attachments

·
Registered
Joined
·
130 Posts
Discussion Starter #4
Thanks for the help guys I finally got it done the only tricky part was getting it off the ground everything else was just plug and play.
 
1 - 4 of 4 Posts
Top