Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter #1
Once the nut is removed, how hard/difficult is it to remove the Hub Assembly?

Does it need to be removed with a puller?

It the hub press fit or just held in place by the nut that is tighten at 221 lbs/ft?

Thanks, Daniel.
 

·
Registered
Joined
·
517 Posts
Im almost positive you need a puller and theirs also a tool to push the new one back in even
 

·
Registered
Joined
·
1,162 Posts
I could be wrong on this, but I don't think the front wheel bearing assemblies are serviceable on these cars. I think you just replace them. A bolt on process.
 
1 - 3 of 3 Posts
Top