Ford Mustang Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter #1
I was about to bite the bullet and go the Sniper throttle body route but upon reading the directions it says Holley recommends 3/8" fuel line. Has anyone done the swap but stayed with the 5/16" line? I just installed a new 5/16" line back in February and really don't want to replace it again for 3/8" if it isn't really needed. Thanks in advance!
 

·
Registered
Joined
·
1,529 Posts
I felt pretty strongly that I should follow Holley's advice and put in a new 3/8" Cu-Ni line in my '66 289. I used the old 5/16" line as the return.
 

·
Registered
Joined
·
6,336 Posts
Most of the systems are supply-return so just put in new 3/8".
 
  • Like
Reactions: Beechkid

·
Registered
Joined
·
132 Posts
Discussion Starter #4
Yeah, that's what I was afraid of. I'm going to hold off on this project until I start my new engine build. Thanks for the help.
 
1 - 5 of 5 Posts
Top