Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
ok heres the deal i have a trick flow intake manifodl r series i took it off changed the upper plenum gasktets and intake manifold gaskets when i pulle dit off alot of wat came out not sure where it all went down but looks like it went in a few places near spar plus nopw it will just turn over but not start up it has startee up for for a sec cat even give it gas to stayy runnin not sure wat to do checked out to make sure it has spark to distrubator it does tried timing wasnt that either so wat else can i do??? and i heard to push the water out but if that doesnt work then wat is it???
 

·
Registered
Joined
·
4,809 Posts
Could you spell check and use some periods or commas. It's hard to read.
 

·
Registered
Joined
·
897 Posts
dude;start by removing the plugs,then crank the engine to get out any coolant or water which you may have. reinstall plugs then try to start the engine.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top