Ford Mustang Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I'm trying to install the cowl to hood seal on my 66. I thought it should just clip in but we broke two of the clips already. Anyone have suggestions, we tried pushing, tapping, we got one in but the clip bent and wouldn't hold. Thx. Mick
 

·
Registered
Joined
·
964 Posts
the clips that come already installed in the rubber should be easy to just push in with both your thumbs, could be you have a lot of paint build up in the holes. Make sure the seal you have is for a 65-66 not like a 67-68. It should just clip in easy with all the clips then on the ends are L shaped metal brackets held in with 2 screws on each side.
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #4 ·
Thanks, were gonna clean out the slots and try it. We have the correct piece, too many hands helping maybe!! Waiting on new seal.
 

·
Registered
Joined
·
663 Posts
I just returned one that the clips broke off the rubber. I got a new one but am waiting for paint to be finished before attempting the install again. Those clips break off way too easy.
 
1 - 6 of 6 Posts
Top