Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello I have an issue with my (11674) on my mustang GT. When I had my exhaust installed the installer welded my catback to my to the catalytic converter x-pipe (was spliced into my stock h-pipe). Now I want to upgrade my system to an off road x-pipe from magnaflow but I cant because its a 3 inch catback system and since it was welded to the stock hpipe they will have to cut which means the flanged 2 1/2 sized that is part of the mandrel tubing will be cut off. As far as I know this will make mating the inch tubing to the 2 1/2 inch tubing of the off road x pipe very difficult if not impossible. Do they make a clamp for this issue? Anyone know of some replacement mandrel bent tubes are for sale? I have attached a couple of photos any advice helps
 

Attachments

·
Registered
Joined
·
927 Posts
OMG thank you for doing this thread. now i don't have to. im looking for the answer to this too
 

·
Banned
Joined
·
9,216 Posts
a good exhaust guy could do it for you. mine is tops.....

hes good with a bender and welder.....
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top