Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Finished with the rear modes and went to start removing front struts, but ran into problem removing sway bar end link from strut. the usual nut and bolt on one side, but some sort of plastic cover on back side. When you turn nut bolt also turns. do you need to remove plastic to hold bolt from rotating and how do you remove plastic. Thanks
 

·
Registered
Joined
·
766 Posts
Yep...Try a 5/16 socket to hold the stud and use a 15mm open end on the nut. Lots of guys will get a clunk from this when they put it back together because they did not get the nut tight enough. You have to hold the stud to get a good torque. GA
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top