Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
232 Posts
A problem for you

hi! dne' here! I have nothing better to do, so I thought I would take a stab at this!:gringreen
As you can see in the photo, and I have to figure that you have not installed any other kind of aftermarket seats? Some people go through a great deal of work by having to relocate the seat platform! I would think removing the seat platform, then modifying it to the height that you want, and maybe even moving it back a few inches to allow for more leg room. Some even remove the seat platforms all together and install seats from, say, an E36 BMW that mounts directly to the floor. This particular seat may not be the best example though. I didn't go with the BMW seat cause my floor pan wasn't in the best of shape. But if you're wanting to use your factory seats, then modifying the seat platform is going to be the only way I know. May be a good time to install new carpet too?:bigthumbsup I hope this helped somewhat.
dne'

 

·
Registered
Joined
·
232 Posts
quite a task

Hi again! I would classify this as quite a task if you have no metal working/welding experience. Obviously all the carpet, underlayment stuff has to come out(good time for new carpet?). How are the existing floor pans in your stang now? Have they ever been replaced? You can look underneath the car and inspect the floor pans from down below, but I think you'd know if your floor pans were in bad shape. Once the carpet is removed, or at least pulled back out of the way to expose the floor pan in question, then spot welds have to be drilled out, cut to separate the seat platform from its welds. It will more than likely be destroyed(but an experienced person may able to salvage it cause it will have to be modified anyway, and new access to the seat bolts have to be made as the seat is being moved). However a new seat platform is not that expensive. If you just don't want to mess with it, then you'll have to find someone. perhaps a nearby restoration shop, or body shop may be able to do it. Determining the height of your newly positioned seat platform is up to you and your metal man/bodyman. Your existing carpet is conformed to fit the existing platform configuration and will require some "fixin". I honestly think it wouldn't be a terribly expensive thing to have done, unless there is additional repairs/floor pan repairs needed. Maybe figuring roughly shop rates of 70 bucks an hour x how many hours to do it? 2-3 hours maybe? plus new carpet, seat platform, etc.). Hope this helps.:bigthumbsup

what would be involved in removing them? i dont know how to do metal work so id have to get it done. If cutting and welding is required any idea what it would cost to get it done and what would be needed to fit the seats directly to the floor?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top