Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Can someone tell me what all is needed to do a five lug disc brake swap from a 95 sn-95 V-6 car? My car is a 88 gt four lug.I will use the 8.8 rear axle that came with the 88. Can i still use the master cylinder from the 88 or will i have to use the 95? What about brake lines and hoses? Any if not all info would be helpful and appreciated. Thanks!!!!!! :worship
 

·
Banned
Joined
·
4,476 Posts
you will need to pull the splindls, rotors, calipers, hoses and modify the lines up front. It is best to take the booster, master and distribution block. I would get an adjustible brake bias valve. In back, you will need the axle shafts, anti-moan brackets, rotors and calipers. FRPP also sells e-brake cables for this swap. You will need to modify or fabricate almost all of your lines. I would google the FRPP M-2300-K brake kit for the directions on how to do this, since the ammount of work is the same. Also, you WILL need a set of camber caster plates
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top