Ford Mustang Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Registered
Joined
·
23 Posts
How do you put on a Hood Scoop?
 

·
Registered
Joined
·
23 Posts
Discussion Starter #3
What post?

What post from what bottom?
 

·
Registered
Joined
·
232 Posts
the third post down from the top by yellow bullitt
 

·
Registered
Joined
·
100 Posts
Yeah 3m double sided tape works great just watch out when you wash your car there's still some water under the scoop that runs out for hours it seems like. Water spots o.o
 

·
Registered
Joined
·
54 Posts
Depends on the scoop in question really.

I did a CDC Shaker, and that was a cut into the hood job.

Most of the other ones are just double sided tape.

Whichever floats your boat!
 

·
Registered
Joined
·
1,355 Posts
Usually either 3M Tape or on some, screws
 

·
Registered
Joined
·
2,867 Posts
i wouldnt trust 3M tape for this...

i knew someone whose taped-on scoop flew off on the highway.
 

·
Registered
Joined
·
2,148 Posts
If you have a factory scoop, just mount it like the factory does.

The stock hood has small cut-outs where the factory studs in the scoop mount.

Check them before drilling, but they are pretty accurate locators.
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top