Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
Ok guys i recently put long tube headers on my 02 gt. When i did the check engine light came on, so i turned off my o2s with my diablo tuner. After i turned the o2s of the car ran horrible stumbling and falling on its face. So i turned the 02s back on and the car runs fine once again but now the check engine light is back on. Is there any suggestions for what i could do to have my light off and still have a great running car?
 

·
Registered
Joined
·
179 Posts
You may want to do some research on MIL Eliminators and see if that would solve the problem with your current set up. Check out this article to get you started.

Ford Mustang Long Tube Header Install
 

·
Registered
Joined
·
34 Posts
More than likely MIL Eliminators are the issue. I have the same issue when I instaled an o/r Hpipe with the check engine light. MIL Eliminators cleared them right up.
 

·
Registered
Joined
·
51 Posts
Discussion Starter · #4 ·
thanks guys i actually had just placed the order for them before i posted this thread, and its good to see that some other people think that might take care of the problem
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top